|

|
|
AMP 4 Pin CPC Connector
The most common radar connector, used by DICKEY-john, Agco, Case Magnum tractors and nearly all planter monitors. A full compliment of “Y” and adapters are available. Connection is also common on Rawson controls and “Smart Boxes.”
|
|
|

|
Weather Pack 4 Pin Square Connector (Deere)
Commonly used by Deere with the Magnavox Radar, and more recently by Case on 4WD, Maxim and MX tractors. Caution should be exercised when dealing with this connection as the two major companies wire it differently.
|
|

|
Ford/New Holland - CASE
This connection used on Genesis and later tractors, is found by following the wiring up from the Radar. Radar Y and adapters are available. We can install this connector on radar units to connect to the tractor system - P.N. 1900-0005.
|
|

|
Detusch - Caterpillar
This connection is found on all Cat tractors after the A and B series. Y cables that plug into this connection are available with single monitor connections or for multiple monitors.
|
|

|
Cannon “Sure-Seal” - Caterpillar A & B Series
Push together connector used on early Caterpillar tractors. Similar connection is used on Hiniker Monitors and Controls.
|
|

|
|
Deere “In Cab” Connection
This connection plugs into a 2 pin metri-pack shroud which is tucked behind the fuse panel in 8000 and 9000 series tractors. Adapters with 1, 2 or 3 outlets are available.
|
|
|

|
|
Case MX “In Cab” Connection
This connection plugs into the outlet on the right window post of the tractor. Available from Vanguard are adapters to any type or combination of monitors.
|
|